Spohn Performance | Support Center

How do I measure and know the length I need for a custom driveshaft?


We can build a custom drive shaft for almost any application. To order a custom built driveshaft see our custom driveshaft page.



measure a custom driveshaft

Measurements: Follow these instructions to provide us with the information needed to build your driveshaft:

1. Enter your transmission type (ie. TH350, TH400, Powerglide, 700R4, Muncie, etc.)
2. Enter your rear end type
3. Open the Picture attachment below - Measurement Directions
4. With your car at ride height - suspension loaded (weight of vehicle on the rear), measure and record Measurement "A". Also record Measurement "B".

Note: On Measurement "A" you are measuring the distance from the center of the rear u-joint to the rear edge of the transmission tailshaft seal. Measurement "B" is the distance from the rear edge of the tailshaft to the rear edge of the output shaft.

Maximum LengthMeasurement "A" maximum length = 63.00".




Bookmark and Share

Article Details

Last Updated
24th of May, 2010

Vehicle Application
Other / Universal

Would you like to...

Print this page Print this page

Email this page Email this page

Post a comment Post a comment

Subscribe me

Remove from favorites Remove from favorites

Remove Highlighting Remove Highlighting

Edit this Article

Quick Edit

Export to PDF

User Opinions (7 votes)

100% thumbs up 0% thumbs down

How would you rate this answer?



Thank you for rating this answer.

Continue