We can build a custom drive shaft for almost any application. To order a custom built driveshaft see our custom driveshaft page.
Measurements: Follow these instructions to provide us with the information needed to build your driveshaft:
1. Enter your transmission type (ie. TH350, TH400, Powerglide, 700R4, Muncie, etc.)
2. Enter your rear end type
3. Open the Picture attachment below - Measurement Directions
4. With your car at ride height - suspension loaded (weight of vehicle on the rear), measure and record Measurement "A". Also record Measurement "B".
Note: On Measurement "A" you are measuring the distance from the center of the rear u-joint to the rear edge of the transmission tailshaft seal. Measurement "B" is the distance from the rear edge of the tailshaft to the rear edge of the output shaft.